Applications:
1994 - 1997 LT1/LT4 Camaro/Firebird
1998 - 2002 LS1 Camaro/Firebird
1994 - 1996 LT1 Corvette
1997 - 2000 LS1 Corvette
2004 LS1 Pontiac GTO
1994 - 1996 LT1 Impala
1996-2000 GM Truck/SUV 4.3L, 5.0L, 5.7L, 7.4LGM
Get 47 percent more airflow
than stock & pick up
over 10-15 hp gains at the rear tires!!!!
Increase the performance of your engine with Granatelli Motorsports
Billet Mass Air Ends! These high flow components replace the restrictive
factory aluminum inner and outer MAF ends. Working in conjunction
with your factory MAF electronic sensor, the GMS MAF ends increase
airflow potential to over 1000 CFM!
Just look at the picture comparing the factory aluminum MAF end
to GMS's high flow design! The difference is obvious.
Featuring a billet aluminum construction, these MAF ends remove
the restrictive center dividers and screen that are present in
the factory design.
Unlike other brands, these housings are machined in one piece
which mean that the inside of the shells are smooth for the best
possible airflow!
Installation:
The MAF ends take less than 5 minutes to install and only require
a couple of hand tools. No modification is required to any factory
components so you can go back to stock at any time. You will receive
the billet inner and outer MAF ends to work with your factory
electronics with your choice of blue, red, satin or black.
For specific applications note listed above, look at your factory
GM MAF center and match it up to the picture shown. Most GM V8
LT1 & LS1 trucks use the same MAF sensor making these ends
compatible.
All orders ship immediately with tracking information via www.UPS.com
or www.USPS.com |
|
